鼠标USB线 试验项目-.pdfVIP

Cable Standard Evaluation Procedure for Mouse Product 4.0 Cirris Test 4.1 Purpose The Cirris test is used in each subsequent portion of this procedure to determine electrical integrity of the cables under test both before and after each procedure is performed. 4.2 Test Setup Set up test and conduct according to Cirris manual guidelines (see reference documents, Section 1.) 4.3 Parameters (unless otherwise specified on cable drawing) ß Resistance threshold…………………….. 1.3 Ohms ß Insulation resistance………………… 10 Megohms ß Hipot voltage…………………………..….. 300 Volts ß Hipot duration…………………………….. 10 Milliseconds Procedure (H00047) Rev J Page 9 of 25 Microsoft Confidential Cable Standard Evaluation Procedure for Mouse Product 5.0 Flex Life Test 5.1 Purpose To ensure that the cable can withstand flexure at the strain relief without shorting or breaking any conductors. 5.2 Test Setup 5.2.1 Calibrate flex-cycle tester to 45 past normal in each direction (90 total). 5.2.2 Adjust holding pins to secure mouse, if necessary. 5.2.3 Set tester to 30 cycles/minute and 10,000 cycles (Mouse) or 5,000 cycles (Receiver). 5.2.4 Cable must pass Cirris test per Section 4. 5.2.5 Tools/Equipment to be used: ß Flex-Cycle Tester ß Elastic bands ß 200 g weight with tightening collar ß Complete mouse case assembly for cable under test 5.3 Procedure