钢筋结构型式（Reinforcement structure type）.docVIP

钢筋结构型式（Reinforcement structure type） (a) construction technology 1, steel production Steel production, steel processing and to design review, check whether there is material errors and omissions for each bar to press the material table to check whether meet the requirements, after the two checks, and then press the sheet out of the samples, can be produced in batches before trial qualified, good steel processing to supervise the orderliness. In the construction of such as the need for reinforcement replacement, we must fully understand the design intent and substitution properties of materials, strictly abide by the provisions of the existing reinforced concrete design specification, steel reinforced high strength low strength and not by substitution of the area. All the important parts of the substitution, must obtain the consent of Party A, the design unit agreed, and a written notice shall be substituted. (1) the steel surface should be clean, sticky oil, dirt, rust before use must be clean, can be combined with the cold drawing process of rust. (2) steel bars, available mechanical or artificial straightening. After straighteningthe reinforced no local bending bending die of small wave shape, the surface scars should not make the reinforced section decreases 5%. (3) reinforced steel cutting should be based on the number, diameter, length and number, length of collocation, the material is cut short cut long material, to reduce and shorten the reinforced short head, to save steel. (4) reinforcement hook or bending: The steel bar hook. There are three forms, respectively, semi-circular hook straight hook and cable hook. Bar bending, bend endothelial contraction and skin extension, axis length bend forming arc, bend after the size of not more than material size, should consider THEBENDING adjustment value. Bending center diameter is 2.5D, the straight part of 3D. Reinforced hook to increase the length of the theoretical calculation value: the rotating semi-circular h