道路结构计算书（The road structure calculation）.docVIP

道路结构计算书（The road structure calculation） ************************************* 双阳区岭上商圈道路结构计算书* * ************************************* 路面结构计算软件为《沥青路面设计与验算系统（apds97）》 轴载换算及设计弯沉值和容许拉应力计算 序号车型名称前轴重（KN）后轴重（KN）后轴数后轴轮组数后轴距（M）交通量 1 49 101.6 1 600双轮组黄河jn150 2日野kf300d双轮组＜3 500 2 40.75 79 3 33 67 1 100双轮组太湖xq641 4黄海dd690 56 104 2 3 20双轮组 5东风cs938 24 70 2 3 10双轮组 设计年限10车道系数0.6 序号分段时间（年）交通量年增长率 1 4 8% 2 3 7% 3 3 5% 当以设计弯沉值为指标及沥青层层底拉应力验算时： 路面竣工后第一年日平均当量轴次：1359 设计年限内一个车道上累计当量轴次：4151110 当进行半刚性基层层底拉应力验算时： 路面竣工后第一年日平均当量轴次：1017 设计年限内一个车道上累计当量轴次：3106460 公路等级三级公路 公路等级系数面层类型系数基层类型系数1.2 1 1 路面设计弯沉值：34.2（0.01mm） 层位结构层材料名称劈裂强度（MPA）容许拉应力（MPa） 1细粒式沥青混凝土1 0.47 2中粒式沥青混凝土0.8 0.34 3石灰粉煤灰碎石0.7 0.46 4石灰粉煤灰碎石0.6 0.4 5石灰土0.25 0.13 新建路面结构厚度计算 公路等级：三级公路 新建路面的层数：5 标准轴载：bzz-100 路面设计弯沉值：34。 2 (0.01mm) The design of pavement layer: 5 The design of minimum layer thickness: 15 (CM) Layer structure layer material name thickness (CM) compressive modulus (MPa) 1 fine asphalt concrete 41200 2 grain type asphalt concrete 61000 3 lime fly ash gravel 151500 4 lime fly ash gravel 151400 5 lime 550? 6 of the 30 According to the design deflection value calculation of layer thickness: LD= 34.2 (0.01mm) H (5) = 15 cm LS= 30.8 (0.01mm) Due to the design thickness of H (5) =Hmin LS=LD, The deflection calculation has to meet the requirements. Pavement design thickness: H (5) = 15 cm (only considering deflection) Check the thickness of pavement frost: The minimum thickness of 61 cm antifreezing pavement The result indicates that the total thickness of pavement thickness is small than 5 cm minimum pavement frost, The program will automatically in the design of the road just to be filled in the lower thickness. According to the design thickness of pavement frost rounding and insufficient thickness of part added to the pavement The lowest level, finally get the pavement structure design results are as follows: Fine grained asphalt concrete cm 4 Grain type asphalt concrete cm 6 Lime fly ash gravel 15 cm Lime fly ash gravel 15 c