手表佩戴尺寸（Watch size）.docVIP

手表佩戴尺寸（Watch size） According to the principle that the golden aesthetic standard size (mm) Wrist width standard table size standard size width wrist wrist width standard table size 7043.2661 37.7052 32.14 6942.6460 37.0851 31.52 6842.0259 36.4650 30.90 6741.4158 35.8449 30.28 6640.7957 35.2348 29.66 6540.1756 34.6147 29.05 6439.5555 33.9946 28.43 6338.9354 33.3745 27.81 6238.3253 32.75 Analysis of the causes of failure of periodic Watch Familiar with the people all know watch watch is subtle is the strict mechanical timing device, a trace of each parts are appropriate not just from the functional perspective, timing It is also very accurate loyalty, is to watch whats wrong is regular. This is mainly the end by its manufacturing precision and meticulous, and the gear teeth Bite operation but also the strict according to the rotate speed of implementation, that is to say each table in the core of the wheels are rotating cycle alone, and can pass on the dial pointer On letting out. Everyone can watch this unique characteristics, to understand their watches, if encounter watch fails, also can be used to judge his watch The fault in there? Below lists the typical failure to explain that: (1) watch every 1 hours on stop and go; this fault is generally the core wheel or tooth has a problem, if the old watch, and the eye was wearing the splint shaft related That will make the core shaft hole wear wheel in the splint heel, extremely easy to cause the pointer indicating the number of seconds a minute in front and on the clock dial character or rub, and two needles and thin Watch Get to the table inside the glass. (2) watch moon, approximately every 7 hours would stop and go; this failure is usually round box spring tooth, or shaft wear eye is too large, the spring In a box of splint which is due to tilt, a round box every 7 hours to rotate one circle. (3) this device handsetting moon system can also undergo periodic noise, block touch feeling, gnawing teeth to decide which on