电瓶搭线方法（Battery line method）.docVIP

电瓶搭线方法（Battery line method） Close the 2 car all electrical equipment Bad car car cathode electrode Good car with bad negative car body ground The car will start again bad start the successful rescue, generally have to wait for a few minutes. The car stalled, bad car rescue harness removed car down cathode cathode Bad car body line removed, the car pulled down the negative Bad gas in the car for 10 minutes or half an hour waiting for idle battery charging cannot flameout --------------------------------- The cathode is connected with the anode, cathode is connected to the anode, and then the line, it does not expressly! But there is one point, do not reverse, that would be a big problem! --------------------------------- The negative electrode is connected with the grounding metal called or ground, can be connected to the positive electrode cathode electrode with metal grounding --------------------------------- How to connect the battery to? I dont get it。 Are you asking how to connect the battery? The cathode is connected with the anode, a cathode is connected with the anode. Battery series: electrode negative (24V) constant current, The voltage increases. Parallel: a positive electrode connected to the positive electrode (12V) current increases, the voltage constant. ---------------------------------- [procedures] A red head clip 1, link cable (+) to the terminal of the battery cathode. Another red clip head 2, connecting cable (+) to the terminal of the battery cathode. A black clip head 3, connecting the cable to the negative (-) good battery. 4, the cable of another black clip head and the engine shell or car body is connected. 5, start, please finish operation, there should be a 10 second cooldown between adjacent two start. 6, uninstall the cable installation procedures in accordance with the reverse steps. [note] 1, in strict accordance with the operating procedures. 2, check the two battery voltage indication, ensure voltage two battery of the same. 3, shut