管理与实务00（Management and practice 00）.docVIP

管理与实务00（Management and practice 00） 26 masonry structure static calculation scheme is rigid, elastic and elastic 27 slag cement mixing large concrete curing time shall not be less than (21) days The stress characteristics of 28 continuous beams, there is a positive moment across, the support is negative moment 29, the main base level telescope level composition 30 with different reinforcement ratio, beam along the diagonal section (a baroclinic shear compression failure form of cable-stayed). 31, the large volume concrete pouring has been completed, in order to ensure that the new pouring concrete hardening conditions, to prevent early due to the dry shrinkage crack, should be covered and watered in 12 hours. The concrete curing time of Portland cement mixed with not less than 14 days; the concrete curing time of slag cement, Portland cement mixing volcano ash not less than 21 days 32, water consumption per unit volume is the main influencing factors of concrete workability 33, the workability including the fluidity, water retention 34, FCU refers to the concrete (compressive strength) Cement concrete with 35, winter construction, priority should be given to the selection of high activity, high hydration heat (Portland cement, Portland cement). 36, in addition to the basement, the combustion performance of grade of interior decoration materials without window of the room, except for Grade A, should improve the level in the standard based on the regulations. The installation of gypsum board, steel keel on combustion properties of B1 mineral wool acoustic board, can be used as a decoration materials. The distribution box inside the building should not be directly installed in the below B1 level of decoration materials 37, the heat transfer coefficient and window wall ratio unchanged, heat consumption index (with shape coefficient proportional). 38, the children often contact (1.3m) exterior wall below should not be rough 39, when the concrete apron, advised by (20-30