手绣制作教学大纲.doc

益民职业技能培训学校 教学计划与大纲 职业等级： 手绣刺绣工 ：初级 2014年4月 《 传统手工——刺绣、扎染、编织》教学大纲 课程总学时：64 学分：3 开课对象：艺术设计服装专业 课程类别：专业基础；必修 一、说明 （一）课程性质：《传统手工》课程是艺术设计专业的专业基础必修课程之一。本课程强调学生在理解多种传统手工技艺理论的基础上掌握了解的发展历史，掌握的表现手法为设计同时提高美术修养了解的发展历史，掌握提高美术修养为设计刺绣概述源流流派历代刺绣民间刺绣特点和种类的表现手法 教学内容（按章填写） 学 时 课堂讲授 实验课 习题课 讨论课 1 第一章 刺绣工艺 5 15 5 2 第二章 扎染工艺制作 5 15 5 3 第三章 手工编织技艺 4 10 （五）教学方式： 通过本门课程的学习学生要了解理论的基础上掌握 3、作业辅导、讨论、讲评与作品的分析、讨论相结合。 二、正文 第一章 刺绣工艺 教学要求：1、要求学生了解刺绣概述源流流派历代刺绣民间刺绣特点和种类刺绣概述源流流派历代刺绣民间刺绣特点和种类类别：直绣、盘针、套针、擞和针、抢针、平针、散错针、编绣、施针、辅助针、变体绣类种，主要有齐针、抡针、套针、施针、乱针、滚针、打子、结子、网绣、挑花、纳锦、穿珠针等 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material tec