XX社区服务站邻里互助计划项目实施方案doc.docVIP

成华区XX街道XX社区服务站 邻里互助项目实施方案 一、活动名称 “和谐邻里 幸福XX”邻里互助 二、活动背景 为贯彻落实党的十六届六中全会精神弘扬邻里团结、互助和睦的传统美德，融洽邻里亲情，建设安定祥和、温馨和谐的新型社区，推进文明城区创建工作向纵深发展指导思想以三个代表重要思想和十六届六中全会精神为指导，以“争做文明市民、建设和谐社区”为目标，以“科学发展、共建和谐”为主题，牢牢把握社区群众的需求，引导居民群众树立“以社区为家”、“以社区为荣”、“与社区共进步”的意识，形成人人支持、户户参与、共同发展的良好局面，拉近邻里间的距离，促社区新风形成，为构建和谐、幸福社区做出贡献。“邻里学”、“邻里情”、 “邻里帮”、 “邻里和”、“邻里乐”、 “邻里颂”六个方面重点开展活动，倡导邻里之间互知、互敬、互帮、互信、互促，活动为媒介，义工是主角，带动社区居民搭建起互助网络 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part p