下载电子步骤.doc

下载电子书步骤： 1、打开百度 2、在白色的框里输入电子书下载，： 3、点击百度一下，转到下个页面： 4、里面有很多网站，选择一个，这里选择奇书网，选择自己想看的书籍： 选择这本书，然后将页面拉到最下面有： 然后点下载地址里面的迅雷下载，就会有这个页面，页面样子稍有不同没有关系，注意“下载到”这一栏。可以点小三角选择，选择到你能找到的文件夹，点下载。 下载的东西就是这样的 下载完就是： 右键单击这个文件会出现一个菜单栏有许多选项，要选择“解压到当前文件夹” 这个电子书就解压成 选择这种文件 打开就是电子书 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be