太极拳协策划方案.doc

振扬太极拳协会（宗派） 策划机构：振扬太极拳协会 日期：2013年11月11日 目 录 前言 陈式太极拳协会章程 前言 太极拳合于大道，效法阴阳，融汇儒释，的哲拳和国拳是中华文化之愧宝，是中华民族灿烂的国粹之一它是集健身、、等功能于一体，是老幼皆宜的健身运动。由热爱太极拳事业的个人或集体而自愿结成发扬太极，强身健体。任务是联络和团结广大太极拳爱好者学习、普及、规范、研讨、弘杨太极拳运动，以拳会友使太极拳这一中华文化之愧宝在得到进一步的继承和发扬，达到全民健身的目的。本会自愿接受业务主管部门和社团登记管理机关的业务指导和监督管理。同时，严格遵守国家法律法规和社会道德风尚融汇中华博大精深文化精髓的太极拳帮助崇尚健康的人们走出亚健康，提升生命品质。组织与异地的太极拳交流、观摩和学习积极参与其它武术活动的学习、交流。积极参与政府组织的大型社会活动。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supp