物流沙盘拟演练.doc

企业经营模拟沙盘演练实 验 报 告 学院(系)： 经济管理学院 姓 名： 专业班级： 物流xxx 实验名称： 企业经营模拟沙盘演练 2011 ~ 2012 学年 第 2 学期 实验日期： 17周 指导教师： xxxxx 成 绩： 审阅教师： xxxxx 教 务 处 实 验 报 告 一、小组分工： CEO：xx xx CFO：xxxxx CHO：xx xx CMO：xx xx CPO： xxx xxx 业务总监：xx 二、实验目的： 从实习中认识和学习系统及在企业运营中的重要性，身临其境的操作，真正感受一个企业经营者面的市场竞争的残酷，经营风险与责任。在实习过程中体悟企业经营管理的关键,了解真实企业的运营过程，了解对企业管理的解决之道。从实习中认识和学习系统及在企业运营中的重要性，身临其境的操作，真正感受一个企业经营者面的市场竞争的残酷，经营风险与责任。在实习过程中体悟企业经营管理的关键,了解真实企业的运营过程，了解对企业管理的解决之道。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, m