陶瓷锦砖地面施工工艺标准(708-1996)（Standard for construction of ceramic mosaic tile (708-1996)）.docVIP

陶瓷锦砖地面施工工艺标准(708-1996)（Standard for construction of ceramic mosaic tile (708-1996)） To not step on paving brick paved, should be back to operation. 3.1.7 dressing: the whole paved, the brick on the mat of wood, standing around the repair at the pad corner, and brick ground and other ground at the door to take rub repaired, ensure straight joint. 3.1.8 brush water, paper: puwan after evenly brush water on paper, at room temperature 15 ~ 30min paper will be wet (if not wet to watering) can start, the paper at this time, and to keep hair clean paper. 3.1.9 dial slot (should be in slurry with complete layer before the final setting): the paper, through the check in time is uniform, smooth straight seam, with smaller than the operation on foot gently smooth dial, straightening, and will be adjusted by the brick pitch plate to take real knock (Bai at the same time, plate with a hammer) has been missing off, paste up brick particles. Around the brick floor drain, nozzle etc., according to the pre trial laying slope cutting, to do tile and mosaic mouth closely coincide. In the above dial gap adjustment process, to keep 2m feet check flatness, the deviation is less than 2mm. 3.1.10 filling: 22 days after the dial slot (or slurry with layers after final setting), with white cement or brick with the same color cement slurry to wipe seam, silk cotton dipped in paste from the inside to the outside seam rub, rub, rub with real, and timely Kam surface brick ash clean, prevent pollution of surface layer. 3.1.11 maintenance: ceramic mosaic ground seamed after 24h, should be covered with sawdust at room temperature curing (or covered by plastic film), the curing time is no less than 7d, and no man. 3.1.12 winter construction: indoor operation temperature not lower than +5 DEG C, not frozen sand block, brick surface layer without icing phenomenon. The curing stage must cover the surface. quality standard 4.1 ensure the project: the ceramic mosaic varieties, specifications, color, qual