GPRS线网络数据远程监控方案.doc

GPRS无线网络远程监控系统 本套智能自动化控制远程监控系统主控单元采用一台具有联网功能的计算机和GPRS无线网络数据终端，用户需开通一张具有GPRS网络数据流量的手机卡，支持中国联通或者中国移动号段（130、131、132、134、135、136、137、138、139、145、147、150、151、152、155、156、157、158、159、182、183、185、186、187、188），其它未列出的号段，系统不支持，再搭配我们的主控制单元来实现GPRS无线网络自动化远程监控。 本控制系统使用特点：在现场可能会遇到这样的情况，分布在不同地方（车间、控制室场所等）的需要与总控中心的进行远程，通常情况是采用有线RS485总线敷设电缆，通过协议完成此功能。如果在几公里范围内的话可以采用无线电方案，如果现场距离总控中心距离非常远，几千米甚至几千公里。就用移动GPRS网络，这样的话就没有距离限制了，比较适合远程无线通信。家用商用工业电工电气设备、制冷设备、电热设备、洗衣设备 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounti