基于EON的模具仿真分析.docVIP

天津职业技术师范大学 Tianjin University of Technology and Education 毕 业 论 文 二〇一三年六月 天津职业技术师范大学本科生毕业论文 典型三板注射模具的三维虚拟拆装及运动仿真 The 3D virtual disassembly and motion simulation of a typical three plate injection mold 2013年 6月摘 要 传统的模具拆装实训由于受到设备成本、拆装场所、维护保养等条件的限制,很难达到预期的教学效果。基于虚拟现实技术的模具虚拟拆装仿真系统,能够保证实训教学不受时间、空间的限制，减少对实训设备的投入和维护，极大提高了传统模具实训教学的质量。 采用虚拟现实开发软件EON Studio对典型三板注射模具—“双分型面、定距拉板、点浇口、推板推出注射模具”进行了三维可视化虚拟拆装及运动仿真的设计和研究。主要完成了以下几个方面的工作：分析了该三板注射模具的典型结构及工作原理，以及成型零件及分型的过程和方法；对该模具的装配和拆卸过程做了进一步的分析和研究；对模具各组成零件进行测量并使用SolidWorks三维造型软件建立了三维模型；使用3ds max对三维模型进行渲染；在EON Studio平台上进行虚拟拆装及运动仿真；用VBscript脚本进行二次开发实现对模具的注塑动态过程仿真；在VC++环境中对模具的拆装考评系统进行编程实现，最终完成典型三板注射模具的三维虚拟拆装及运动仿真。 关键字：三板注射模；模具结构；虚拟仿真 ABSTRACT Traditional mold dismantling training due to the cost of equipment, dismantling sites, maintenance and other conditions, it is difficult to achieve the desired teaching effect. Based on virtual reality of the virtual disassembly mold simulation system, to ensure the practical teaching from time and space constraints, reduce investment and maintenance training equipment, greatly improving the quality of traditional mold practice teaching. Using the virtual reality software EON Studio to design and research the three-dimensional visualization and motion simulation of virtual disassembly of the typical three-plate injection mold - Double parting surface, Fixed pitch drawing board, The point of intersection and The push plate Release injection mold. Completed the following aspects of work: Analysis the typical structure and working principle of the three-plate injection mold and molded parts and typing processes and methods. Do further analysis and research on the assembling and disassembling processes of the mold; Measure the constituent parts of the mold and used 3D modeling software – SolidWorks to model their three-dimensional model; Render three-dimensional model by 3ds max; Completed virtual disassembly and motion simulation based on EON Studio. Do the secondary development on VBscript to