城关教育践活动实施方案_20140420.doc

城关镇党的群众路线教育实践活动 实 施 方 案 按照中央、省委、洛阳市委、偃师市委关于开展党的群众路线教育实践活动的有关要求，根据《中共偃师市委关于在全市党员中深入开展党的群众路线教育实践活动的实施意见》，现就开展我镇党的群众路线教育实践活动，提出如下实施方案。 一、总体要求　　 严格按照中央、省、市委明确的指导思想、目标要求和方法步骤开展教育实践活动，坚持“照镜子、正衣冠、洗洗澡、治治病”的总要求，把贯彻落实中央八项规定、《党政机关厉行节约反对浪费条例》等规定作为切入点，进一步突出作风建设，下大功夫、下大力气解决“四风”问题， “五查五看五争当” the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the original v