成都华涛自达6睿翼汽车音响改装曼斯特和博亚四门隔音.doc

成都华涛马自达6睿翼汽车音响改装曼斯特和博亚四门隔音 改装方案：前声场：曼斯特CS6508IV二分频套装 后声场：曼斯特2C6512同轴 隔 音：四门博亚隔音 四门隔音，博亚止振王粘贴在车门钣金上，止振， 前声场高音原喇叭位在车门上，直接更换喇叭就是了 原车中低音是6.*9的，纸质盆面，表现力非常一般 曼斯特CS6508IV的中低音安装 后声场中低音，在安装的过程中喇叭都是经过防振和防水处理 马自达6睿翼小改完成，虽然只换了喇叭，但是比原车提升了不少，音质非常干净，人声的表现力无可挑剔。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the original values conf