流量检测共服务平台.doc

计划类别： 2013_CP2 南通市科技计划项目申报书 （科技公共服务平台） 项 目 名 称： 流量检测公共服务平台技 术 领 域 计量检测技术 建 设 地 点：港 闸区 国 强路 119号 南通计量所 申 报 单 位： 南通市计量检定测试所 共 建 单 位: 项目负责人: 电 话： 联系人： 电 话： 主 管 部 门: 申报日期：2012年12月20日 南通市科学技术局 二〇一二年制 流量检测公共服务平台 一、组建的意义及必要性 主要服务内容项目建设地点、主要任务及考核指标 （1）设施建设任务 （2）服务的主要内容 （3） （4）建成后水平、（5）管理 （6）四、项目实施计划 1、投资 2、建 3、组建 4、 五、申报单位及共建合作单位意见（盖章） 主管部门审查推荐及匹配经费意见（盖章） 附件： 1、承担单位上年度财务报表 2、合作共建的需附相关协议 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finis