浅析低温气能热泵技术如何选型及应用.doc

浅析低温空气能热泵技术如何选型及应用 本文主要介绍PHNIX超低温空气源热泵“北极星”系列机组在商用场合和家用场合的应用以及设备选型。 （一）商用场合 样板工程照片 中国电信集团西藏分公司那曲公司 大雪中的PHNIX“北极星”超低温空气源热泵机组 1、项目介绍： 北极星系列 PASRF250S-PS/PAXRW060*4 共10台。 本工程为中国电信集团西藏分公司那曲分公司，新建生产大楼以及6栋住宅楼需要做供暖，生产大楼供暖面积为6290m2，住宅楼供暖面积为3970m2。其中生产大楼需要一天24小时供暖，住宅楼每天供暖时间约为10小时，供暖采用超低温空气源热泵。本工程位于西藏自治区那曲地区，只考虑冬季取暖问题。采暖季节为每年的10月到次年的5月底，设计采用超低温空气源热泵供暖的时间为240天。 2、当地气候说明： 那曲地区海拔较高，热量不足，气候严寒干旱，含氧量仅为海平面的一半，藏北高原是西藏气候条件最恶劣的地区之一，是典型的亚寒带气候区。高寒缺氧，气候干燥，昼夜温差大，多大风天气，年平均气温为－0.9至－3.3，年相对湿度为48－51%，年均降雨量仅在100-200毫米之间,年日照时数为2852.6－2881.7小时，全年无绝对无霜期。 3、工程特色 采用 2、家用“北极星”综合节能解决方案 3、 “北极星”系列机组的参数表 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gas