王延臣简_王延简历-中国讲师网.doc

 讲师姓名 王延臣 职称 生产管理咨询专家 擅长培训领域 　　　　　北京大学总裁班讲师 　　全国专业人才培训中心讲师 　　中国管理科学研究院讲师、咨询师 　　全国高工委特聘生产管理顾问培训师 　　中国质量认证中心咨询授课讲师 　　中国讲师网等多家培训机构讲师，咨询师 王延臣讲师部分培训客户 　　1、班组长培训主要客户 　　红塔集团班组长综合管理技能提升(2天) 　　双汇集团打造卓越班组(2天) 　　双汇集团五型班组建设(2期4天) 　　北京现代摩比斯班组长培训(2天*2期) 　　江苏摩比斯班组长TWI培训(2天) 　　恒安集团班组长培训(2天) 　　古井贡集团班组长培训(2天) 　　宁夏电力公司班组长(2天) 　　内蒙古电力班组长综合管理能力培训(3天) 　　大唐许昌发电公司(2天) 　　云南天高镍业班组长综合管理技能(2天) 　　北京环卫集团班组长现场执行力(3天*2期) 　　　江苏一汽铸造股份有限公司内训讲师; 　　北京现代摩比斯TPM内训讲师; 　　中国重汽集团福建海西汽车有限公司; 　　江西昌河航空工业有限公司 　　国药控股星鲨制药有限公司 　　白云机场TPM 　　皖能发电设备管理 　 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing.