controller design considerations for acm apfc systemsacm apfc系统的控制器设计问题.pdfVIP

Hindawi Publishing Corporation Advances in Power Electronics Volume 2012, Article ID 286861, 9 pages doi:10.1155/2012/286861 Research Article Controller Design Considerations for ACM APFC Systems Alexander Abramovitz Department of Electrical Engineering and Computer Science, University of California, Irvine, CA 92697, USA Correspondence should be addressed to Alexander Abramovitz, alabr@ Received 27 February 2012; Revised 6 August 2012; Accepted 7 August 2012 Academic Editor: C. M. Liaw Copyright © 2012 Alexander Abramovitz. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This paper is concerned with performance of the current shaping network in Average Current Mode (ACM) Active Power Factor Correction (APFC) systems. Theoretical expressions for the ripple components are derived. Then, ripple interaction and impact on the current loop reference signal are investigated. A modification of the controller network is suggested that results in an improved Total Harmonic Distortion (THD). Design guidelines are suggested. The theoretical predictions were validated by simulation. 1. Introduction of the implementation, however, the duty cycle program- ming is implemented according to the converters input port Over the past few years, a variety of current shaping method- ideal average relationships and ideal modulator ramp signal. ologies were developed for Active Power Factor Correction As a result, accurate current loop operation can only be (APFC) [1–3]. Each approach un