constitutive rheological modeling of flow serration behaviour in metallic glasses showing nanocrystallization during deformation锯齿状流动行为的本构流变模型在金属玻璃显示nanocrystallization变形.pdfVIP

Hindawi Publishing Corporation Journal of Nanomaterials Volume 2011, Article ID 910962, 8 pages doi:10.1155/2011/910962 Research Article Constitutive Rheological Modeling of Flow Serration Behaviour in Metallic Glasses Showing Nanocrystallization during Deformation M. A. Yousfi,1 K. Hajlaoui,2, 3 Z. Tourki,1 and A. R. Yavari3 1 LMMP LAB-STI03, Universite de Tunis, ESSTT, Tunis 1008, Tunisia ´ 2 LGM-MA05, ENIM, Av. Ibn El Jazzar, Monastir 5019, Tunisia 3 SIMaP-LTPCM, Institut National Polytechnique de Grenoble, 38402 Saint Martin d’Heres, France Correspondence should be addressed to K. Hajlaoui, k.hajlaoui@yahoo.fr Received 25 April 2010; Revised 26 June 2010; Accepted 16 July 2010 Academic Editor: Quanqin Dai Copyright © 2011 M. A. Yousfi et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. A simple micromechanism-inspired rheological model is developed that incorporates the serrated flow nature of metallic glasses subjected to compressive deformation at room temperatures. The process of propagation and the arrest of shear bands were addressed in this model. Shear-induced nanocrystallisation was believed to be responsible for strain hardening of material within the shear bands. The model is based on the assumption that the behaviour can be decomposed into two resistances acting in parallel: one captures the initial stiffness and shear softening and the second gives the time-shear-temperature hardening of material. 1. Introduction structural and functional applications. While