dynamic detection on airflow for vehicle intake system based-on hot-film anemometry sensors车辆动态检测气流吸入系统基于hot-film风速测定传感器.pdfVIP

Journal of Transportation Technologies, 2011, 1, 1-6 doi:10.4236/jtts.2011.11001 Published Online January 2011 (http://www.SciRP.org/journal/jtts) Dynamic Detection on Airflow for Vehicle Intake System Based-on Hot-Film Anemometry Sensors Rong-Hua Ma, Tsung-Sheng Sheu Department of Mechanical Engineering , ROC Military Academy, Kaohsiung, Taiwan, China E-mail : rh.ma@ Received November 12, 2010; revised December 17, 2010; accepted December 28, 2010 Abstract The goal of this study is to develop an airflow meter sensor for vehicle intake system detection in internal combustion engines. The study uses micro-electromechanical process technology to develop a hot-film flow meter with an alumina substrate and platinum film heater; the hotline method is used to create a micro air- flow anemometry meter sensor relying on variations in resistance of the platinum film corresponding to dif- ferent wind velocity at the set temperatures. The micro-sensor is less bulky and simpler structure than ordi- nary meters, and its small size enables it to provide good sensitivity and measurement precision. The alumina plate used in this study is produced by polishing an alumina substrate, a platinum film is then deposited on the plate to complete the micro-heater used in the sensor. Resistance on the sensor side varies as gas flows through the sensor, and the instrument determines airflow velocity on the basis of the changes in resistance caused by gas flow differences. Airflow velocity form 10 m/s to 60 m/s are used to test. Resistance displays a regular slope, indicating the relationship between airflow velocities varies remain predictable throughout the sensing range. Therefore, the sensor can achieve its airflow measurement purpose completely. Keywords: Vehicle Intake System, Detection, Anemometry, MEMS 1. I