上柴C6121发动机故障分析.pdfVIP

ENGINE ERROR Usually, these two errors often happen about the engine. I collect some data about reasons and diagnosis ways to share with each other. Error one: Engine can not start. This is a usual problem. Usually, the appearance and reasons are divided into these things. Appearance: The start motor can’t turn the engine. When the start motor can’t turn the engine, you should mainly check the start electrical system. You can do it as follows: The start system error diagnosis process: Diagnosis: First check the wire between storage battery and start motor. Then check the capacity of the power, sometimes there is not enough capacity because the low temperature. Check the oil viscosity, at another hand low temperature aslo can lead the oil viscosity becoming high. If it is not the above reason, it may be the machanical problems. For example, the start motor is damaged or the power is bad. You have to change a new one. Appearance: The motor can turn the engine but the engine has no premonitors to start. In this situation, first you should check the low pressure oilchannel and then check the high pressure oilchannel. The low pressure oilchannel diagnosis process There is enough oil in the tank, the switch is on and the air vavle is good. There is foam in the fuel Unscrew the nut for discharging the fuel, press the hand pump, and watch the oil flowing situation. There is some air in the low pressure oilchannel, you should discharge the air. Pull the hand pump out and then relase it suddenly. The hand pump can be back