Cu-6%Ag合金组织纤维化过程中的应变协调行为.pdfVIP

Vo1.42 No.9 第 42 卷第9 期 令品营址 2006 年 9 月 931-936 页 ACTA METALLURGICA SINICA Sept. 2006 pp.931-936 Cu-6%Ag 合金组织纤维化过程中的应变协调行为 * 刘嘉拭孟亮 (浙江大学金属材料研究所，杭州 310027) 擒 • Cu-6%Ag 合金(质量分数)原始组织由枝品偏析的 Cu iI体和不平衡共晶体两种组成物构成，冷拉拔及中闷热处理 可辱~组织纤维化.通过测量纤维化过程中组成物的尺寸变化以及计算各组成物的名义应变和应变F曹长率，分析了不同组成份之间 的应变协调行为.在不同的变形阶段，两种组成物应变硬化能力不同，导致应变程度和应变地~率存在兹别.随合金变形程度的地 加，两种组成物在演变为纤维复合组织的过程中，应变程度和应变憎长率并不保将一致.表现出一定程度的应变不协调俊 关键词 Cu-Ag 合金，微观组织， 应变 中图法分~号 TB331 , TG146.3 文献标识码 A 文章编号 0412-1961(2006)09-0931-06 STRAIN CO孔1PATIBILITY BEHAVIOR IN Cu-6%Ag ALLOY DURING DRAWING INTO FILA如iENTARY STRUCTURE LIU Jiabin, MENG Liang College of Matcrials Science and Chemical Engineering, Zhejiang University, Hangzbou 31∞27 Correspondent: MENG L iang, professoη Tel: (0571 E-mail: mengliang@zj钮. edu.cn S叩po俨ted by National Natural Science Foundation of China (NO.5ω71076) Manuscript re四ived 2006-0 1- 23, in revised forro 2∞6--{)4-14 AB STRACT Cu-6%Ag (m础fraction) microcompo剖旬， of which the primary structure consists of dendritic Cu matrix and non-equilibrium eutectic colonies, was prepared by heavy cold drawing and intermediate heat treatments. The scales of different mÌcrostructural components were determined at different draw ratios and the strain compatibility was discussed by evaluating the strain level and s也rain increase rate for eaεh m icrostructural component. The microstructural ∞mponents d ísplay dilferent strain levels and strain increase rates in different ranges of drawing strain because both have different characters of strain hardening . Therefore, the strain level and strain increase rate show a non-