压力容器O形金属密封环的回弹行为研究SpringbackBehaviorof.PDF

See discussions, stats, and author profiles for this publication at: /publication/263735431 Springback Behavior of Metal Sealing O-rings Used to Pressure Vessel Conference Paper January 2010 CITATIONS READS 0 28 3 authors, including: Cai Lx Southwest Jiaotong University 174 PUBLICATIONS 370 CITATIONS SEE PROFILE Some of the authors of this publication are also working on these related projects: fatigue View project All content following this page was uploaded by Cai Lx on 09 July 2014. The user has requested enhancement of the downloaded file. 2010 年海峡两岸材料破坏/断裂学术会议 压力容器O形金属密封环的回弹行为研究 姚博 蔡力勋 江亚男 西南交通大学力学与工程学院，成都 610031 摘要 依据一系列试验和弹塑性接触单元有限元分析，对室温下 60Si2Mn 钢、304 不锈钢、钛合金的 O 形环试样回弹行为进行了研究。结果表明，在O 形管状试样的压缩比 d/D （d 和 D 分别是试样的压缩量和 管外径）的较大范围内，回弹比 H/D 和几何比 D/t 之间存在线性关系（H 和 t 分别是试样的回弹量和厚 度）。提出一个用于 O 形环回弹量预测的 TSM 模型，实验表明，该模型对这三种金属材料 O 型环试样的预 测结果和实验结果具有很好的一致性。 关键词 304不锈钢; 60Si2Mn;钛合金;O 形环;回弹量;预测模型;有限元分析;密封 Springback Behavior of Metal Sealing O-rings Used to Pressure Vessel YAO Bo CAI Lixun JIANG Yanan Department of Applied Mechanics and Engineering, Southwest Jiaotong University, Chengdu 610031, China ABSTRACT Based on a series of tests and elastic-plastic finite element analysis (EPFEA) with contact elements, the springback behavior of O-ring specimens of three materials:60Si2Mn, SS304 and T225NG at room temperature were investigated. The results show that, in a larger range of flattening ratio d/D for a tube specimen of O-ring where d and D are flattening displacement and outer diame