a convenient method for manufacturing tio2 electrodes on titanium substrates一个方便的方法生产二氧化钛电极钛基板.pdfVIP

Hindawi Publishing Corporation International Journal of Photoenergy Volume 2011, Article ID 373210, 4 pages doi:10.1155/2011/373210 Research Article A Convenient Method for Manufacturing TiO2 Electrodes on Titanium Substrates Wei Qin,1 Songtao Lu,2 Xiaohong Wu,2 and Song Wang2 1 School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China 2 Department of Chemistry, Harbin Institute of Technology, Harbin 150001, China Correspondence should be addressed to Wei Qin, qinwei@ Received 11 June 2011; Revised 15 September 2011; Accepted 15 September 2011 Academic Editor: Leonardo Palmisano Copyright © 2011 Wei Qin et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Thin titanium dioxide films were successfully prepared on titanium plates in ammonium sulfate solution with the micro-plasma oxidation method. The thin TiO films were sensitized with a cis-RuL (SCN) ·2H O (L = cis-2, 2 -bipyridine-4, 4 -dicarboxlic 2 2 2 2 acid) ruthenium complex, and implemented into a dye sensitized solar cell configuration. The influence of current density on the surface structure and photoelectric performance of the TiO2 films was investigated. The results show that the thin TiO2 films are porous, and the dye-sensitized solar cell based on the film prepared at 14 A/dm2 has exhibited higher overall light-to-electricity