压线器的使用（Use of wire press）.docVIP

压线器的使用（Use of wire press） Concrete adjustment method of pressure limiter Adjustment method of A and noise gate 1, the threshold (THRESHOLD): adjust the mixer total volume down, the system do not have a little human audio signal, turn the adjusting knob, see the red light indicator gate open a can, but can not transfer too much, otherwise useful to suppress the music. Like the sluice gates mentioned above, it is better to raise the standard than the standard, even if some water is intercepted. 2, recovery time (RELEASE): noise gate recovery time and compressor recovery time is slightly different, can be appropriately longer, in general, should be about 500 ms more appropriate. B, compressor and limiter adjustment method Different pressure limiters have different adjustment knobs and parameters, but the following 4 points are the most basic standard function knobs for most voltage limiters: 1, threshold (THRESHOLD) adjustment According to the regulation of the threshold to adjust the compression ratio, the most simple way is to turn off the power amplifier, the limiter before the peripheral equipment to the normal working state, then the maximum volume mixer volume up to the normal performance of the position, basically at the level of the signal on the console indicating lamp will light red light. Then adjust the limiter threshold (THRESHOLD) to adjust the knob, limiter in compression indicator lights start flashing, said the limiter has already started to work, then the threshold (THRESHOLD) is a good tune. It should be noted that the compression ratio must be opened, to be greater than 1:1, otherwise the voltage limiter is equal to the straight through, and there is no limit. 2, compression ratio (RATIO) setting compression ratio to set a certain extent, too small to play the role of pressure limit, too large, it will cause the dynamic range of music narrowing, sound dry tasteless. In general the show can be set in a compression ratio of about 3:1; in such a large