15-波峰焊技术的应用现状与未来 ___（Application of 15- wave soldering technology and future ___）.docVIP

15-波峰焊技术的应用现状与未来 ___（Application of 15- wave soldering technology and future ___） Application status and future of wave soldering technology What kind of wave soldering method is adopted in the process of production, such as avoiding defects, inert welding, productivity, air knife, bridging technology and machine selection? In most need of miniaturization of products is still in use perforation (TH) or mixed technology circuit boards, such as televisions, home audio-visual equipment and the upcoming launch of the digital set-top box, still in the perforated element, therefore need to use wave soldering. From a technical point of view, the wave soldering machine can provide only a little bit of the most basic adjustment of equipment operation parameters. Production process When the circuit board enters the crest welder through the conveyor belt, it passes through a certain form of flux coating device where the flux is applied to the circuit board by means of wave crest, foaming, or spraying. Since most soldering fluxes must be reached and maintained at an activation temperature to ensure full penetration of solder joints, the circuit board passes through a preheating zone before entering the wave trough. The preheating of the flux coating can gradually increase the temperature of the PCB and activate the soldering flux. This process also reduces the thermal shock produced by the assembly when it enters the crest. It can also be used to evaporate moisture absorption may all carrier solvent or dilution of flux, if these things are not removed, they will be in the wave crest when boiling and cause solder sputtering, or produce steam in solder pad or blisters formed inside the hollow. The length of the preheat section of the wave soldering machine is determined by the throughput and conveyor speed. The higher the output, the longer the preheat zone is needed to allow the board to achieve the desired infiltration temperature. In addition, due to the large heat capacity of