cadcamcae的有关资料（Cadcamcaes information）.docVIP

cadcamcae的有关资料（Cadcamcaes information） The influence of CAM on high speed machining Although the research on high-speed machining has been going on for many years, there is a lack of clear and concise definitions and explanations for high-speed machining. The basic starting point of high speed machining is cutting under high speed and low load. It can be cut more quickly and at higher load, and the material can be cut more quickly. Low load cutting means reducing the cutting force and thus reducing vibration and deformation during cutting. With a suitable tool, high hard material can be cut at high speed. At the same time, high speed cutting allows most of the cutting heat to be removed by chip, thereby reducing the thermal deformation of the parts. These advantages can only be achieved in the case of appropriate processing strategies. If the use of inappropriate processing strategies, light will lead to a reduction in tool life, while heavy may lead to more terrible results. One thing to keep in mind is that high-speed machining is not simply the use of existing tool paths that are achieved by increasing spindle speeds and feed rates. Tool path for high speed machining There are many limitations to the tool path in high speed milling. When these restrictions are listed one by one, the reasons for these limitations are clear. 1. the tool can not collide with the parts 2. the cutting load must be within the limit load of the tool 3. the residual material shall not exceed the specified limit 4. sudden changes in the rate of material removal should be avoided 5. cutting speed and acceleration must be within the range of machine tools 6. cutting direction (progressive milling / reverse milling) shall be kept constant 7. sudden changes in cutting direction shall be avoided 8. minimize the movement of the empty path 9. cutting time should be reduced to the minimum However, it is difficult to satisfy all of these requirements in the process of tool path planning. In fact,