串模干扰共模干扰概念以及抑制方法（The concept and suppression method of common mode interference in series mode interference）.docVIP

串模干扰共模干扰概念以及抑制方法（The concept and suppression method of common mode interference in series mode interference） The conditions used in the field of industrial production are often very complicated. The measured parameters are often converted to a weak low-level voltage signal and transmitted to a two meter or computer system over long distances. Therefore, in addition to the useful signals, there are always some voltages or currents that are independent of the signals being measured. This irrelevant voltage or current signal we call interference (also known as noise). There are many sources of interference, usually we call interference is electrical interference, but in general, thermal noise, temperature effects, chemical effects, vibration and so on, may affect the measurement and cause interference. In the measurement process, if the interference can not be ruled out, the instrument can not work properly. According to the interference mode of instrument input, it can be divided into series mode interference and common mode interference. The series mode interference is the interference which is superimposed on the measured signal. The common mode interference is the interference between any input terminal and the ground. Interference comes from the sources of interference, which may exist both inside and outside the instrument. Outside the instrument, some high-power power equipment and power equipment may become interference sources, and the power transformers, electrical appliances, switches and power lines in the instrument may also become interference sources 1) suppression of series mode interference The serial mode interference is the same as that of the signal under test, so it is difficult to eliminate the interference of the series mode. So we should prevent it from happening first. Measures to prevent cascade interference are generally listed below: * signal wire twist. Because the signal conductors are twisted together to make the signal loop encircling ar