产品内部的电磁兼容性设计（EMC design of products）.docVIP

产品内部的电磁兼容性设计（EMC design of products） 1 electromagnetic compatibility in printed circuit board design 1.1 common impedance coupling problem in printed circuit board Separate the ground from the ground. 1.2 layout of printed wiring boards But for high speed, medium speed and low speed mixing, pay attention to the layout of different regions. The low of analog circuit and digital logic separation. 1.3 wiring of printed wiring boards (single or double sided) The special zero volt power line line, the line width is greater than or equal to 1mm. The power line and ground line as close as possible, the whole power supply on the printing plate and to The well pattern is distributed so that the distribution line current is balanced. You must provide a zero volt line for special analog circuit. But to reduce the crosstalk, when necessary, can increase the distance between the lines of print, care Place some neutral lines as line separation. The plug printed circuit is to arrange some zero volt line as line isolation. Please pay special attention to the current size of the wire loop in circulation. If you may be in the line of control (in printing plate) the entrance to pick up R-C. Coupling so as to eliminate possible interference in transmission. Please dont print on the linewidth of arc wire mutation, dont suddenly (over 90 degrees) around the corner. 1.4 useful advice on the use of logic circuits on printed wiring boards We all can not do not need high speed logic circuit. But between the power supply and adding decoupling capacitors. Please pay attention to the waveform distortion in long distance transmission. The R-S match between the trigger button and electronic circuit buffer. The power line interference and suppression method introduced in the operation of 1.4.1 logic circuit Distortion problem in output waveform transmission of 1.4.2 logic circuit Coordination between 1.4.3 button operation and electronic circuit operation 1.5 interconnection of printed wiring boar