LC谐振放大器(郭1).doc

摘要：系统由程控衰减模块、前置放大模块、LC谐振放大模块和带通滤波模块组成。衰减模块由π型无源衰减器构成。放大模块由可调放大环节和 LC 谐振放大环节组成，其中放大环节由芯片 AD603 搭建。LC 谐振放大环节由分立元件搭建，最终可以实现手动增益的连续可调。 整个系统可实现15MHZ小信号40dB衰减，输入放大器后实现80dB高增益放大,输出级40dB范围内自动增益可控，末级经功率放大电路后驱动200Ω负载电阻。总的来说，本系统基本符合指标的要求。 关键字：衰减器，放大电路，LC 谐振，AGC自动增益，高频小信号 Abstract: The system is composed of program-controlled attenuator module, a preamplifier module, LC resonant amplification module and the band pass filter module. Attenuation module byπtype passive attenuator. Amplifier module by adjustable amplifying link and LC resonant amplification circuit, the amplifying link by AD603 chip set. LC resonant amplifying link is set up by the discrete components, finally can realize manual gain continuously adjustable. The whole system can be realized 15MHZ small signal attenuation of 40dB, after the 80dB input amplifier high gain amplification, the output stage 40dB range automatic gain control, final through a power amplification circuit to drive the 200 Ωload resistance. In general, this system basically meets the requirements. Keywords: attenuator, amplifying circuit, LC resonance, AGC automatic gain, high frequency small signal 目录 一、前言…………………………………………………………………4 二、总体方案设计………………………………………………………4 1、增益控制部分………………………………………………………………………4 2、LC谐振放大部分…………………………………………………………………5 3、总体方案描述………………………………………………………………………5 三、理论分析与计算……………………………………………………5 1、衰减器………………………………………………………………………………5 2、谐振频率……………………………………………………………………………5 3、放大倍数……………………………………………………………………………6 4、-3dB带宽…………………………………………………………………………6 5、选择性——矩形系数………………………………………………………………6 四、单元模块设计………………………………………………………7 1、衰减电路……………………………………………………………………………7 2、第一级放大电路设计………………………………………………………………7 3、后级LC谐振放大电路……………………………………………………………8 4、滤波…………………………………………………………………………………8 五、放大器各项性能指标及测量方法…………………………………9 1、测试仪器……………………………………………………………………………9 2、测试方案和结果……………………………………………………………………9 六、结论…………………………………………………………………10 七、参考文