宽带钢热连轧机自由规程轧制的板形控制技术_曹建国.pdfVIP

OI :10.13374/j.issn1001 -053x.2009.04.015 31 4 Vol.31 No.4 2009 4 Journal of University of Science and Technology Beijing Apr.2009 1) 1) 1) 2) 2) 2) 曹建国 　轧　楠 　米凯夫 　宋　平 　鄢檀力 　蔡海斌 1), 100083　2)(), 430083 　　“”, ASR-C . ANSYS ., ASR-C , , , ASR-C . 1700mm 2.55mm×1280mm “”ASR-C . , ≤45μm 41.8% 98.2%, 53μm 33.9% 1.8%, ASR-C88%.ASR-C , “” . 　;;; 　TG333.7 Profile and flatness control technology for schedule-free rolling in hot wide strip mills 1) 1) 1) 2) 2) 2) CAOJian-guo , YA Nan , MI Kai-f u , SONGPing , YAN Tan-li , CAI Hai-bin 1)School of Mechanical Engineering, niversity of Science and Technology Beijing, Beijing 100083, China 2)Wuhan Iron Steel (Group)Co., Wuhan 430083, China ABSTRACT　In order to meet the requirement of schedule-free rolling for wide non-oriented electrical steel strip production with a large number of the samewidth strip rolling campaigns, an asymmetry self-compensating work rolls (ASR-C)technology was devel- oped.A three-dimensional finite element analysis model of roll stacks was built by ANSYS software package.The finite element analysis and industrial tests indicate that the developed ASR-C technology has both crown control ability and wear control ability for different widths of strips or different rolling periods within the entire rolling campaign.At the same time, the roll gap stiffness and the crown control range by bending forcewith asymmetry self-compensating work rolls are greater than thosewith conventional work rolls in hot finishing mills.The ASR-C technology has been applied to production of the same strip-width 2.55mm×1280mm wide non-oriented electrical steel strips in the 1700mm hot strip mill of WISCO for test.The industrial test results show that the rate of the measured strip