工程计算规则（Engineering calculation rule）.doc

工程计算规则（Engineering calculation rule） According to the size and amount of rock engineering calculation allows the overbreak volume in cubic meters. The width and depth of groove and pit on each side to allow overexcavation quantity: soft rock, hard rock, hard rock: 150mm 200mm Mechanical removal of concrete barriers were removed by the component volume in cubic meters calculation. Artificial cut reinforced concrete pile head under pile by the pile head length multiplied by the cross-sectional area of the cut to cubic meter. Overhead layer: a layer of the frame columns are empty, in the above ground Sleeper wall: the beam is located in a layer below the surface, and a layer of floor, in order to prevent a layer of ground subsidence A cast-in-place concrete project is calculated according to the following provisions 1, the volume of concrete works unless otherwise stipulated, according to the icon size entity volume in cubic meters calculation. Do not deduct the steel, embedded iron plate and wall holes in the volume of 0.3 square meters. 2, the foundation: the concrete foundation and the partition wall or column, according to the basis of expanding the top surface is a circle. The frame type equipment foundation shall be separately according to the foundation, columns, beams and plates corresponding quota calculation. Based on the equipment floor according to beam plate quota calculation. The basic equipment is not included in the anchor bolt fixed value. The anchor bolt should generally be included in the value of complete sets of equipment, such as the anchor bolts are not included in the value of the value of complete sets of equipment, anchor bolts should be calculated according to the actual weight. The first order using the strip foundation template at the same cross section, have executed with corresponding basic quota items; without the use of templates and water along the groove strip foundation according to this chapter concrete foundation cushion implementa