电工试题4（Electrical examination questions 4）.docVIP

电工试题4（Electrical examination questions 4） I. judgment questions 1. Besides the enough mechanical strength, the cross section of the wire must satisfy the heating temperature through the normal maximum load current. (V) 88 2. The insulation performance of the low voltage line shall be measured before the power supply is completed, and the insulation resistance between the phase line and the phase line shall not be less than 0.38M. 89 (V) 3, after the breakdown on the line, the switch has tripped, must carry on the fault inspection, in the inspection, if discovered the broken line, all should regard as the electricity. (V) 92 4. AC single core power cable shall not be worn inside the steel tube alone. (V) 95 5. a slot plate for the same loop of wire, in the wide groove plate should be laid in the same phase of the wire, and may not have joint or extrusion. (V) 97 6. When installing temporary power line, one end of power supply should be installed, and finally, one end of power equipment should be installed. (x) 99 －－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－ Two. Fill in the blanks 1, a variety of electrical lines, according to the way they are installed (overhead, cable, home and outside) distribution lines. Eighty-eight 2, the cable metal skin metal ends should be reliable grounding, resistance should be no more than (10) ohm. Ninety-five 3, cable across roads and buildings and leads in height (2) meters in part should wear protective tube, pipe diameter should be not less than the outer diameter of the cable (1.5 times), each tube (1) root. Ninety-five The insulation strength of not less than 4 in the pipeline, AC (500 V), the joint shall not tube, the minimum wire section copper core insulation line (1mm2), aluminum (2.5mm2) as the core insulation wire, wire in the tube shall not exceed (10) root. Ninety-eight 5, the wire through the wall, the use of porcelain pipe (steel pipe) or (plastic pipe) protection. Ninety-seven 6. The steel pipe shall b