第3章++电源电路（The third chapter + + power circuit）.doc

第3章++电源电路（The third chapter + + power circuit） This article is contributed by QSelf-study mobile phone maintenance network training W Gao Shifu QQ:609720468 Third quarter This section focuses on: Structure and working principle of power supply circuit 1, understand the structure of battery pin and external power supply boot method. 2. Understand the structure of switch keys. 3, understand the mobile phone directly powered by the battery circuit. 4, mobile phone power supply circuit structure and working principle. First, the structure and function of the battery foot. There are two kinds of mobile phone batteries and a four foot: (below) Warm feet Quasi negative polar foot Positive pole type pole detection (Figure two) (Figure 1) 1, the battery positive (VBATT) is responsible for power supply. 2, the battery temperature detection pin (BTEMP), the foot detection battery temperature; some machines are also involved in the boot, and when the battery can boot, clip positive and negative poles can not boot, the foot should be connected with the negative electrode. 1 more exciting content, please click enter: mobile maintenance video teaching network Self-study mobile phone maintenance network training W Gao Shifu QQ:609720468 3, the battery type detection pin (BSI) of the battery is electric or hydrogen detection feet of lithium battery, some mobile phone only because the circuit, but the current mobile phone battery for lithium battery, therefore, the foot will save the tripod. 4, battery negative (GND), that is, mobile phone public. Two 、 switch key: mainly used to trigger the power circuit work. There are two triggering modes of the power circuit: high level trigger and low level trigger. In general, one end of the boot button is connected with the ground for low level triggering, and most of the mobile phones use the trigger mode, and the other is triggered by the high level. The trigger voltage is about 2.8-3V (figure below). The red ring is the positive t