oracle建库脚本（Oracle建库脚本）.docVIP

oracle建库脚本（Oracle建库脚本） Using the Oracle user, enter the following command: $vncserver If it is the first operation, then the system will appear prompt information, prompted you to enter the password, which is through the terminal for landing, you need to enter; In addition, there is a digital information, which also needs to be entered at the end of the landing, that is, a colon followed by a number, such as: 1,: 2, and so on, need to remember; 4. In the Windows client, use the vncviewer, enter as follows: xxx.xxx.xxx.xxx:1 or xxx.xxx.xxx.xxx:2, etc., and the latter number needs to correspond with the server side; XXX is the IP address of your server; [linux as 5] software requirements Other version (or later) version of the required package: Gcc-2.96-124 Make-3.79 Binutils-2.11 Openmotif-2.1.30-11 Glibc-2.2.4-31 To see what versions of these packages are installed on the system, run the following command: RPM -q, GCC, make, binutils, openmotif, glibc, setarchp4198954_21_linux.zip, hit before running runInstaller RPM -ivh compat-oracle-rhel4-1.0-5.i386.rpm (p4198954_21_linux.zip) (no PATH is OK.) Install libaio-0.3.102-1.i386.rpm and libaio-devel0.3.102-1.i386.rpm Third CD in Red Hat Enterprise Linux medium Run the following command as root user: RPM -ivh /mnt/cdrom/RedHat/RPMS/ libaio-0.3.102-1.i386.rpm Create database installation preparations: 1, create user/group; Groupadd DBA Groupadd oinstall Useradd, Oracle, -g, oinstall, -G, DBA Passwd Oracle If the nobody user does not exist (see the ID nobody command), create: Useradd nobody2, building the Oracle installation folder (sample); MKDIR, -p, /opt/oracle/10.2.0.1, /opt/oracle/oradata, /opt/oracle/archivelog Chown -R oracle.oinstall /opt/oracle Chmod 755, -R, /opt/oracle2, configure environment variables; To use the Oracle product, several environment variables should or must be set. If you have more than one Oracle product or database installed on the same server, the ORACLE_HOME, ORACLE_SID, and PATH variables