场强单位换算（Field strength unit conversion）.docVIP

场强单位换算（Field strength unit conversion） Field intensity unit and its conversion of electromagnetic radiation The electromagnetic interference field strength unit and its conversion are one of the frequently encountered and concerns problems for the electromagnetic compatibility workers. The field strength of electromagnetic interference includes both the electric field intensity, magnetic field intensity and power flux density, and also has a decibel system. In some cases, units can be converted to one another. This article will make a brief introduction to the use and conversion of these units. I. basic unit of electromagnetic interference field strength There are three basic units in the field of high frequency and microwave electromagnetic interference: electric field intensity V/m, magnetic field intensity A/m and power flux density W/m2. When measuring an electric field, if the instruments head scale uses an electric field intensity unit, it is expressed in units of V/m. When the field intensity of interference is less than 1V/m, m, V, /m and V/m units can be used. When the magnetic field is measured using a ring antenna, a frame antenna, or a magnetic antenna, and the instrument head scale is calibrated according to the magnetic field intensity unit A/m, then the A/m, mA, /m, and mu A/m units are expressed. When the electromagnetic field of high frequency to microwave, the separate measurement of the electric field, magnetic field has a certain difficulty in technology; or power density measurement than the electric field, magnetic field measurement to be convenient, so the power flux density measurement. The unit of power flux density is W/ m2. The omni-directional broadband field strength instrument and radiation risk meter produced abroad are more convenient to realize |E|2 and |H|2 from 260KHZ~26GHZ and test circuit because of their wide range of frequency. Therefore, most power flux density measurements are adopted and the mW /Cm2 is used as the header. Th