A miniature TUBE BENDER My CMS（一个微型弯管机我的CMS）.pdfVIP

A miniature TUBE BENDER Detailed instructions for making a useful workshop fitting together with hints on its use are given by C. Horace Clarke HE PRINCIPLE employed in this tube bender is that Tthe length of material to be bent is held against a semi-circular groove round a cylindrical block while a roller with a similar groove is rolled round the block con- centrically with its axis. There are two methods of operation. The work may be pulled out of a slide and around the bending block, the latter usually rotating with the part carrying the bending roller, The tube bender in use with a 180deg. bend in apipe beside it which could in fact be replaced by a straight groove clamping the work. Alternatively, the work may be detachable bending arm to get the forward turning from mild-steel rod. clamped in a fixed vice while the device on and off the work. The working of the appliance will projecting part is rolled on to the The next variation was a smaller best be seen from Fig. 1. The bending bending block. The latter is adopted edition in steel for bending the cores block, A , is mounted on a general in the present case. of organ chest magnets, consisting of base, B, of 1/4in. steel plate, which for In spite of the lack of novelty, it 5/32in. dia. solid soft iron with an use is held horizontally in the bench may be useful for readers to know internal radius of in. at the bend. vice. The bending roller, C, is pivoted how a small