Design, Analysis and Optimization of Overhead （设计、分析和优化的开销）.pdf

International Journal of Advance Engineering and Research Development (IJAERD) Volume 1,Issue 6,June 2014, e-ISSN: 2348 - 4470 , print-ISSN:2348-6406 Design, Analysis and Optimization of Overhead Crane Girder 1 2 3 Pratik R Patel , Bhargav J Patel , Vipul K Patel 1M.E student in Mechanical Department, S K Patel Engineering College, Visnagar 2Assistant Professor in Mechanical Department, K J Faculty of Engineering, Vadasma 3Assistant Professor in Mechanical Department, S K Patel Engineering College, Visnagar Abstract: In the current material handling equipment the life of the overhead crane as well as the cost of the material handling equipment is too important to stay in the competitive market of the industries. The cost of the material handling equipment is depend on the weight of the material. The performance of the material handling equipment will be done by the working on the optimization of the overhead crane used in the industries. In this project, Design, Analysis and Optimization of the overhead bridge crane girder for the 75 ton capacity is carried out by changing the dimensions of section of overhead crane girder. In Design we are using 750 x 450I section for girder and calculate 2 stress (98.251 肀?肀氻睔 ) ,deformation(9.8844 mm), safe factor(0.87734),and weight(26976 Kg).In 2 the Analysis of girder analyze of von misses stress (98.251 肀?肀氻睔 ) ,deformation(9.8844 mm), safe factor(0.87734). From analysis and analytically we found weight of girder is higher so that optimization is required for the optimize weight of girder.In the optimization, we have selected di