EXPERIMENTAL AND NUMERICAL （实验和数值）.pdf

EXPERIMENTAL AND NUMERICAL INVESTIGATION OF THE THERMAL SEPARATION IN A VORTEX TUBE Lecturer Ionel OPREA, PhD. ”DUNĂREA DE JOS” UNIVERSITY OF GALAŢI Abstract. The original solution for hot end pipe rectifier takes into account the experimental results of V.I.Metenin, S.A.Piralisvili, A.V.Moraskinim, V.A.Vîsocinim. Rectifier control valve equipped with articulated ball execute a oscillation movement. This causes a pulsating radial motion maintenance and even an increase in its kinetic energy for hot mass fraction. Extensive studies have been carried out on hot end pipe rectifier of vortex tubes for developing vortex tube technology. Keywords: vortex tube, pressure regulator, hot end pipe regulator. 1. INTRODUCTION the total temperature of outer fluid decreased and the inner increased. The Vortex Tube (VT) system is a device that It was early recognized that both transport of generates separate flows of cold and hot gases heat by conduction and transport of kinetic energy from a single compressed air. The vortex tube was by friction might contribute to the energy separa- invented by Ranque in 1933 and then improved by Hilsch in 1947. tion represented by the net temperature difference detected between the outgoing streams. It was also Vor