Intel174; NUC Kit NUC5i7RYH User Guide （Intel174;）.pdfVIP

Intel NUC Kit NUC5i7RYH User Guide Intel® NUC Kit NUC5i7RYH User Guide 1 Intel NUC Kit NUC5i7RYH User Guide Before You Begin CAUTIONS The procedures in this user guide assume familiarity with the general terminology associated with personal computers and with the safety practices and regulatory compliance required for using and modifying electronic equipment. Disconnect the computer from its power source and from any telecommunications link or network before performing any of the procedures described in this guide. Failure to disconnect power, telecommunications links, or networks before you open the computer or perform any procedures can result in personal injury or equipment damage. Some circuitry on the board can continue to operate even though the front panel power button is off. Follow these guidelines before you begin:  Always follow the steps in each procedure in the correct order.  Set up a log to record information about your computer, such as model, serial numbers, installed options, and configuration information.  Electrostatic discharge (ESD) can damage components. Perform the procedures described in this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam pad. If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer chassis. Installation Precautions When you install and test the Intel NUC, observe all warnings and cautions in the installation instructions. To avoid injury, be careful of:  Sharp pins on connectors  Sharp pins on circuit boards  Rough edges and sharp corners on the chassis  Hot components (such as SSDs, processors, voltage regulators, and heat sinks)  Damage to wires that could cause a short circuit Observe all warnings