Simple Installation Guide Hitachi Deskstar （简单的安装指南日立这）.pdfVIP

Simple Installation Guide 6. If you are replacing a hard drive, remove the drive from the system. Hitachi Deskstar Note: There are many variations of tower and desktop designs. Below is an example of a typical tower design. 3.5 inch ATA/IDE This document provides instructions to install your Hitachi Deskstar drive in a system. Additional information can be found at www.HitachiGST.com/support Getting Started IMPORTANT! Back up all data before beginning installation. Handling Precautions Caution: Poor handling, physical impact or electrical shock causes most premature hard disk drive failures. • Set the drive down gently to prevent damage from impact or vibration. • Do not open the ESD bag containing the drive until needed. • Handle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components. Configure the Jumper settings • Do not press on the top or bottom of the drive. 1. Remove the drive from the ESD bag. • Do not cover the drive’s breather hole. 2. Record the model (HDS), part number (P/N) Before handling the hard disk drive, discharge any static and serial number (S/N). electricity from yourself and your clothing. With one hand, touch an unpainted, metal surface on your computer chassis, then touch the ESD bag with the other hand. Remain in con- tact with the chassis and the bag for a minimum of two sec- onds. Tools for Installation: You may need one or more of the following items to install the Hitachi Deskstar drive: • A Phillips head