Standard Test Method for Melt Flow Rates of （熔体流动速率测试方法标准）.pdfVIP

Designation: D 1238 – 04 Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer1 This standard is issued under the fixed designation D 1238; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. 1. Scope* Determine the Precision of a Test Method 1.1 This test method covers measurement of the rate of 2.2 ANSI Standard: B46.1 on Surface Texture3 extrusion of molten resins through a die of a specified length and diameter under prescribed conditions of temperature, load, 2.3 ISO Standard: and piston position in the barrel as the timed measurement is ISO 1133-1991 Determination of the Melt-Mass Flow Rate being made. (MFR) and the Melt Volume-Flow Rate (MVR) of Ther- 1.2 Procedure A is a manual cutoff operation based on time moplastics3 used for materials having flow rates that fall generally between 3. Terminology 0.15 and 50 g/10 min. Procedure B is an automatically timed flow rate measurement used for materials having flows from 3.1 General: 0.50 to 900 g/10 min. By both procedures, the piston travel is 3.1.1 For definition of some of the technical terms used in generally the sa