Standard Test Methods for Determining the Izod …（标准测试方法确定悬臂梁式u2026）.pdfVIP

Designation: D 256 – 021 Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics1 This standard is issued under the fixed designation D 256; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. 1 NOTE—Editorially corrected the latest referenced revision year in the Summary of Changes section in September 2002. 1. Scope * of a plastic’s “notch sensitivity” may be obtained with Test Method D by comparing the energies to break specimens having different radii at the 1.1 These test methods cover the determination of the base of the notch. resistance of plastics to “standardized” (see Note 1) pendulum- NOTE 4—Caution must be exercised in interpreting the results of these type hammers, mounted in “standardized” machines, in break- standard test methods. The following testing parameters may affect test ing standard specimens with one pendulum swing (see Note 2). results significantly: The standard tests for these test methods require specimens Method of fabrication, including but not limited to processing made with a milled notch (see Note 3). In Test Methods A, C, techno