SURFCAM Tutorial Xooimage（SURFCAM教程Xooimage）.pdfVIP

® SURFCAM Tutorial An Introduction to SURFCAM: A 2D Numerical Control Project Te c h E d C o n c e p t s , I n c . 5 5 0 Pe m b r o k e S t r e e t Pe m b r o k e , N H 0 3 2 7 5 Tel. (800) 338-2238 Fax (603) 224-8324 Web: www.TEC E-mail: Sales@TEC Chapter 3 • The SURFCAM Tutorial 117 PART 4: A COMPLETE PROJECT 3.13 A 2D NC PROJECT 1. Open a file and create a new Setup Section. 2. Create a pocket. 3. Create the toolpath. 4. Verify the toolpath. 5. Create the NC code. 6. Transfer the NC code to the machine. 3.13.1 Open a file and create a new setup section 1. Open the original 2dribs.dsn file. Tip If you saved the dimensions you created in Create the dimensions on a design, page 79, press the delete key then click on each dimension to delete the dimensions. Copyright © 2002 by Surfware, Inc. All Rights Reserved. 118 Chapter 3 • The SURFCAM Tutorial 2. Press CTRL+7 to change to Isometric view. 3. Click the NC Operations Manager button on the SURFCAM toolbar to display the dialog box. 4. Click the Add a new setup section to the project button on the toolbar of the NC Operations Manager dialog box. Copyright © 2002 by Surfware, Inc. All Rights Reserved. Chapter 3 • The SURFCAM Tutorial 119 5. Enter the name Setup Section Two. 6. Highlight Setup Section Two in the NC Operations Tree and click the Done button. 3.13.2 Select th