炼油厂工艺流程（Refinery process flow）.docVIP

炼油厂工艺流程（Refinery process flow） Refinery process flow 1. delayed coking process: The raw material for vacuum residue device temperature of 90 DEG C, the tank pump device into the raw oil buffer tank, then the raw material is pumped to the diesel fuel oil heat exchanger, heated to 135 DEG C into the raw wax oil heat exchanger, heated to 160 DEG C in the convection section of coking furnace, heating to 305 DEG C in this section of Coking Fractionating Tower overheating, from contact with the top of the coke tower in oil gas heat. The raw oil and oil and gas from coke tower by circulating oil condensate flow into the bottom of the tower at 380 to 390 DEG, with radiation pumped into the radiation section of coking furnace, fast heating up to 495 to 500 DEG C, into the bottom of the tower through the four valve. Circulating oil and vacuum residue in the oil fraction above in coke tower due to the high temperature and long time stay and the occurrence of cracking, condensation and a series of coking reaction, high temperature oil reaction gas outflow from the top of the tower enters the fractionating tower bottom and raw oil heat exchange directly after condensing circulating oil distillate; the large amount of oil and gas increased by five fractionation of washing plates in the control layer, gas temperature evaporation of fuel tank, fuel tank set up into the above fractionation, fractionation. The wax, diesel, naphtha and rich gas are fractionated from bottom to top. Fractionating tower gas oil wax at the temperature of 343 DEG C, gravity to wax stripper, after heat steam stripping after wax from wax oil pump out to provide heat for the stable stable absorption tower reboiler after cooling to 258 DEG C, and then to provide heat for the desorption tower reboiler after cooling to 242 DEG C, into the raw wax oil heat exchanger and the raw oil heat, oil temperature to 210 degrees, then divided into three parts: one part is divided into two paths as oil return fractionating t