碳粉知识大全（Toner knowledge）.docVIP

碳粉知识大全（Toner knowledge） Carbon powder knowledge 1. Specifications of carbon powder HP cartridge type, capacity, applicable model C4129X, 500g, HP, LaserJet, 5000/5000n/5000GN C3903A, 220g, HP, LaserJet, 5P/5MP/6P C2298A, 340g, HP, LaserJet, 4/4+/5M/5N C3900A, 400g, HP, LaserJet, 4V/4MV/4VC 92274A, 160g, HP, LaserJet, 4L/4ML/4P/4MP/4LC C4092A, 140g, HP, LaserJet, 1100/1100A C3906A, 140g, HP, LaserJet, 5L/6L/5ML/6L, GOLD Two, carbon powder introduction 1, the amount of charged (toner charge ratio): toner and carrier saturated friction with the amount of electricity. The charge to mass ratio of the color modulation is expressed in units c/g. Generally, its nominal value is stipulated by the manufacturer of toner, and the limit deviation is + 30%. After matching the carrier to the developer, the amount of charged shall comply with the requirements of the developer. The nominal value of the determination of the current commonly used practice is to measure the OEM model, but because of the limited sample, selection and test vector, is often difficult to determine, then it is difficult to determine accurately and can meet the requirements of the use of the scope of charge, only to come up with a reference range. Therefore, some manufacturers and enterprises use both the actual use and the final quality according to the quality of the copy. 2, softening point: under the prescribed conditions, constant temperature heating, quantitative toner, so that it dissolves melt from the nozzle outflow, when the color transfer amount of 1/2 when the temperature is softening point, the unit is C. Generally prescribed by the manufacturer of toner, its limit deviation is + 6 degrees centigrade. The main softening point is the resin substance in the toner. The use of the product mainly affects the fixation performance. 3, melt index: under the specified conditions, the outflow of carbon dioxide per second nozzle. The properties of the same toner represented by softening point. The unit is