碳粉的基础知识（Carbon powder Basics）.docVIP

碳粉的基础知识（Carbon powder Basics） Carbon powder basics, Post, By:2009-1-9, 10:51:00 1. Specifications of carbon powder GG bottled powder, model HP, cartridge type, capacity, applicable models NT-T4129, C4129X, 500g, HP, LaserJet, 5000/5000n/5000GN NT-T3903, C3903A, 220g, HP, LaserJet, 5P/5MP/6P NT-T2298, C2298A, 340g, HP, LaserJet, 4/4+/5M/5N NT-T3900, C3900A, 400g, HP, LaserJet, 4V/4MV/4VC NT-T2274, 92274A, 160g, HP, LaserJet, 4L/4ML/4P/4MP/4LC NT-T4092, C4092A, 140g, HP, LaserJet, 1100/1100A NT-T3906, C3906A, 140g, HP, LaserJet, 5L/6L/5ML/6L, GOLD Two, carbon powder introduction 1, the amount of charged (toner charge ratio): toner and carrier saturated friction with the amount of electricity. The charge to mass ratio of the color modulation is expressed in units c/g. Generally, its nominal value is stipulated by the manufacturer of toner, and the limit deviation is + 30%. After matching the carrier to the developer, the amount of charged shall comply with the requirements of the developer. The nominal value of the determination of the current commonly used practice is to measure the OEM model, but because of the limited sample, selection and test vector, is often difficult to determine, then it is difficult to determine accurately and can meet the requirements of the use of the scope of charge, only to come up with a reference range. Therefore, some manufacturers and enterprises use both the actual use and the final quality according to the quality of the copy. 2, softening point: under the prescribed conditions, constant temperature heating, quantitative toner, so that it dissolves melt from the nozzle outflow, when the color transfer amount of 1/2 when the temperature is softening point, the unit is C. Generally prescribed by the manufacturer of toner, its limit deviation is + 6 degrees centigrade. The main softening point is the resin substance in the toner. The use of the product mainly affects the fixation performance. 3, melt index: under the specified condition