钢筋翻样和现场断料（Reinforcement checking and on-site cutting）.docVIP

钢筋翻样和现场断料（Reinforcement checking and on-site cutting） Reinforcement checking and on-site cutting Calculation method of reinforcing bar blanking The following describes the bending hook, and there are two kinds of bending, stirrups and other methods of calculation: First: the 1 introduces two kinds, one is straight section, both ends have curved hook, but the curved hook has no definite length: the bent hook has 90 degrees, 135 degrees, 180 degrees, three kinds, the blanking length = straight section length + bend hook added value. (D for rebar diameter) refer to table 1; Bend angleHook added value 3.5D, 4.9D, 6.25D 180, 2, two are curved hooks and curved hooks with length, bending angles of 30 degrees, 45 degrees, 60 degrees, 90 degrees, 135 degrees, several degrees, steel length = length length + hook length - measuring difference. (D for rebar diameter) refer to table 2; Bend angle 30456090135 Hook added value 0.3D, 0.54D, 0.85D, 1.75D, 2.5D 3 has hooked and bent; Blanking length = straight section length + inclined section length + bend hook added value - bending adjustment value, refer to table 1 and table 2. Second: stirrup: blanking length = outsourcing size (inner package size) + outsourcing size adjustment value (inside package size adjustment value) Table 3 adjusting length of stirrup blanking length: Measurement methods / diameter 4 - 56810 - 12 Outsourcing sizeChapter I beam Section 1 frame beam First, the calculation of steel reinforcement 1, the upper through tendons The upper perforated rebar (rib 1 = length on long) through cross span long + two end bearing anchor value 2, end support negative ribs The negative length of end support: the first row is the anchor value of Ln/3 + end support; The second row is Ln/4 end support anchor value 3, lower reinforcement The reinforcement length = span long + about bearing anchor value Note: the result of the calculation is the same for the lower reinforcement, no matter whether it is divided